Moog Music Taurus 3 Bass Pedals - Manual (Page 41)

Page 42
Taurus 3 User’s Manual - The User Interface
Page 43
Taurus 3 User’s Manual - The User Interface
Receiving SysEx Data
The T3 is able to receive System Exclusive data at any time without any special prior setup. SysEx files are
recognized and received automatically whenever a SysEx data transfer is initiated. The T3 LCD screen will
display the status of SysEx data transfers as follows:
SINGLE PRESETS:
The LCD screen will briefly display a ‘RECEIVING SINGLE PRESET’
message whenever a single preset is transmitted via SysEx. The preset
will automatically be written to the current preset location. For ex-
ample, if the current preset location is H4 when the SysEx is received,
the new preset data will be written into location H4.
ALL PRESETS:
The LCD screen will display a ‘RECEIVING PRESETS’ message when a
bank of presets is transmitted. The transmitted bank will replace the
current bank.
BULK DUMP:
The LCD screen will display a ‘RECEIVING BULK DUMP’ message
when a bulk dump is transmitted.
FIRMWARE UPDATES:
The LCD screen will display a ‘RECEIVING FW’ message when a
firmware update is transmitted. Status update messages will appear on
the second line of the display as the transmission executes. After the
firmware update is completed, the T3 will automatically reset and an
‘UPDATE SUCCESS’ message will be displayed.
This option allows you to save the entire state of the T3 (including all
global data and Preset data) for later recovery. To execute a bulk dump,
enable the device that is to receive the SysEx data, then press STORE to
initiate the data transfer.
During data transfer, the LCD will display the status of the transfer
process. When the operation has finished, the display will return to the
SYSEX menu.
SEND FIRMWARE: