Moog Music Taurus 3 Bass Pedals - Manual (Page 39)

Page 40
Taurus 3 User’s Manual - The User Interface
Page 41
Taurus 3 User’s Manual - The User Interface
Allows you to select the MIDI velocity output resolution of the T3. A
setting of FULL provides the full output range (0-127). A setting of 1
provides a fixed velocity output value of 100. A setting of 2 provides
two velocity values, a setting of 4 provides four velocity values, a setting
of 8 provides eight velocity output values, etc. See the table below for
the complete range of all settings. To change the velocity resolution, use
the CURSOR to highlight the parameter, then use the VALUE knob to
select the desired resolution.
Values: FULL, 1,2, 4, 8, 16, 32;
the default is FULL
VELOCITY RESOLUTION:
MIDI SETUP (con’t)
VELOCITY
RESOLUTION
MIDI VELOCITY OUTPUT RANGE
FULL 0 – 127 (continuous)
1 100 (fixed)
2 64, 127
4 32, 64, 96, 127
8 16, 32, 48, 64, 80, 96, 112, 127
16 8, 16, 24, 32, 40, 48, 56, 64, 72, 80, 88, 96, 104, 112, 120, 127
32 4, 8, 12, 16, 20, 24, 28, 32, 36, 40, 44, 48, 52, 56, 60, 64, 68, 72,
76, 80, 84, 88, 96, 100, 104, 108, 112, 116, 120, 124, 127
Allows you to select whether the CONTROL footwheel will transmit
MIDI CC messages as 14-bit values (two bytes) or 7-bit values (one
byte). Regardless of this menu setting, the T3 always responds to 14-bit
CC messages. To change the setting, use the CURSOR to highlight the
ON/OFF parameter, then use the VALUE knob to make the desired
selection.
Values: ON, OFF; the default is ON
14 BIT MIDI: