Printronix T2N User Manual
Page 28
28
6. Adjust media width guide to fit label width.
Adjust media sensor ensuring the gap/black
mark passes underneath the media sensor
indicator (marked by a triangle) for sensing.
7. Push both sides of the pivoting deck down to
close it, ensuring the latches engage
properly.
Note: Pressing down only one side of the pivoting
deck may result in the pivoting deck opening
during printing. This can put the printer in an
unknown state. Be sure to push both sides of the
pivoting deck down and verify that the latch is in
locked position.
8. Use the Configuration Utility to set the media sensor type and calibrate the selected sensor.
Note:
Recalibrate the gap/black mark sensor when changing media.
The sensor location is marked by a triangle ▽ on the sensor housing.
The media sensor position can be moved horizontally. Ensure the gap or black mark is at the
location where media gap/black mark will pass through for sensing.
Media Sensor
Indicator
Media Width Guide