Printronix T2N - Manual (Page 105)

105
Printer Status
The following are two ways to obtain printer status information:
1. From the LEDs on the printer.
2. By using
the “Get Status” button in the Configuration Utility (webpage also has this function).
This section reviews the different types of status that are reported.
Figure 32. Printer Status
Figure 32 shows the Printer Status from the Configuration Utility as well as the LEDs on the actual printer.
C
lick the “Get Status” button to query the printer as desired.
The table below shows different Printer Status types and compares them with the LED settings.
Note: The Power LED is always ON. When a fault has occurred (Status LED flashing), follow the
instructions on page 37 to resolve the fault. Press the Feed key to clear the fault.
Printer Status
Online
LED
Status
LED
Description
Ready ON ON Printer is online and ready to process jobs.
Pause OFF OFF
The printer is offline and paused. Press the green pause
button to return back online.
Printing FLASH ON The printer is currently processing a job.
Head Open OFF FLASH Printhead is open.
Paper Jam OFF FLASH Media is jammed and gap was not detected.
Out of Paper OFF FLASH
Media is not present. If the printer detects the gap
between two labels are bigger than the gap size, the
printer reports
an “Out of Paper” error.
Ribbon End Err OFF FLASH Ribbon is not present.
Ribbon Encoder Err OFF FLASH
The ribbon is not working properly due to a ribbon wrinkle
or jam.
Cutter Error OFF FLASH The cutter is not working properly.
PrintHead Overheat OFF FLASH Printhead is hot.
Calibration Error OFF FLASH
Auto-calibration has failed due to missing media, failure
to detect a gap, etc.
Status LED (Amber)
Power LED (Green) Online LED (Green)
Configuration Utility Status T2N Front Panel LEDs