Printronix T2N - Manual (Page 114)

114
Cutter Reset
Click the “Cutter Reset” button each time a cutter is replaced. This keeps an accurate account of how
many cuts the cutter has performed.
Usage
The Cutter Usage value is the number of cuts that the cutter has performed. When a new counter is
installed, reset the value to maintain an accurate count.
Media/Sensor Control
This section provides advanced control of Media/Sensor options which are not typically needed by
users. By default, all the sensors listed are enabled in the printer. Users can disable these sensors if
desired based on specific application or media.
Head-up Sensor
This menu configures the head-up sensor.

Enable (factory default). Enables the head-up sensor.

Disable. Disables the head-up sensor.
Ribbon Sensor
This menu configures the ribbon out sensor.

Enable (factory default). Enables the ribbon out sensor.

Disable. Disables the ribbon out sensor.
Ribbon Encoder
This menu configures the ribbon encoder.

Enable (factory default). Enables the ribbon encoder.

Disable. Disables the ribbon encoder.