VEGA VVO VEGA Visual Operating - Manual (Page 9)

VEGA Visual Operating 9
Start VVO
In the VVO there are three different
user levels. As
Operator you can make
no modifications on the connected
instruments. Just observation and
monitoring are possible. At
Mainte-
nance configuration of a measurement
loop is not possible. Other functions
such as e.g. adjustment or editing of
linearisation curves are possible. In the
planning level all functions except the
service adjustments are accessible. In
this operating instruction we always
assume that you are in the planning
level. Click to
Planning and then click to
OK. As operator you are not asked for
a user identification. With maintenance
you are asked for a user identification. As planning engineer in addition a
password should be entered. Preadjusted for name and password is
"VEGA“. Later (with started VVO) the passwords can be modified. It is also
possible to deactivate the password inquiry. Click to
OK after you have
entered the name and the password.
This window shows that VVO gets in contact with the connected
instruments.
If this message appears, the failures can be the following:
-
Failure 1: Interface cable or VEGACONNECT 2 not connected
-
Failure 2: Interface cable or VEGACONNECT 2 connected to the
wrong standard interface
-
Failure 3: You have installed an older VVO-version (< 2.20). Use
the older interface converter VEGACONNECT.
Immediately remove, if possible, the failure and click to
Repeat. If the
failure cannot be removed, click to
Cancel and quit VVO. When the
failure is removed, start VVO again.
Choose
Direct cable connection (the operation via
modem is described in the operating instruction "Re-
mote parameter adjustment").