VEGA VVO VEGA Visual Operating - Manual (Page 10)

10 VEGA Visual Operating
Start VVO
To remove failure 2 (interface cable or
VEGACONNECT 2 connected to the
wrong standard interface) you can plug
the interface cable or VEGACONNECT
2 to another socket on the computer.
However it is easier when you change
the choice of the interface used. Click to
Cancel. In the window which is appear-
ing you click in the menu bar to
Con-
figuration, point to Program and click
then to
Communication.
Choose here another interface and
confirm with
OK. VVO tries again to get
in contact with the connected instru-
ment.
The message shows that a VEGACON-
NECT 2 is connected, however that no
additional VEGA-instrument was found
by VVO. Click to
OK. Check if the
bushes of VEGACONNECT 2 are in-
serted and if the connected instrument is
switched on.
When you have removed probable
failures, you can try again to provide
the connection between VVO and the
connected instrument. Click in the menu
bar to
Services, then to Connection (or
push the function key
F8). VVO tries
again to get connection.