Selecting security options (cont.) – TROY Group MICR_IRD 3005 Security Printing Solutions User’s Guide User Manual
Page 57
Section 4
Using the TROY Printer Utility
Security Printing Solutions User’s Guide -- 50-70410-002 Rev. A
4-11
Selecting Security
Options (cont.)
Toner Sensor
Response
H
ALT
– (default) stops all MICR print jobs. The printer control panel will display the message “LOAD
MICR TONER or six more continues will cancel job”. No MICR documents will print.
W
ARN
– pauses all MICR print jobs. The printer control panel will display the message “Non-MICR
Toner, ‘<’ to cancel”. The user must press ‘<’ to cancel or ‘Go’ to continue. If the user cancels the job,
a page will print with the message “This MICR job could not be printed because MICR toner was not
loaded in the printer – JOB PURGED”.
I
GNORE
– allows all MICR jobs to print, regardless if MICR or non-MICR toner is installed in the printer.
F
LUSH
– purges the MICR print job from the printer memory and prints a page with the message “This
MICR job could not be printed because MICR toner was not loaded in the printer – JOB PURGED”.
Alt Command
Set
An optional feature that translates the %& command set into standard PCL (Page Control Language).
Do not enable this feature unless instructed to do so by TROY Technical Support.
Decryption
Password
Φ
To support encryption, a decryption password must be entered that matches the encryption password.
If decryption is not going to be used, leave the decryption password field blank.
Φ TROY MICR Secure Printers, MICR / IRD Secure EX Printers, and MICR Secure Memory Card Kits Only