TROY Group MICR_IRD 3005 Security Printing Solutions User’s Guide - Manual (Page 156)

Appendix IRD 9050 1
UP
Printer Setup Guidelines
S Security Printing Solutions User’s Guide -- 50-70410-002 Rev. A
A-2
Configuring
the TROY IRD
9050 1
UP
Printer for
IRD Forms
(cont.)
1. Ensure the tray selection lever is in the down (custom) position before proceeding (Figure 1 and Figure 2).
Verify that the tray
selection lever is in
the down position.
Figure 1 Figure 2
2. From the printer control panel, press the button. Press the W arrow button until the
PAPER HANDLING menu
appears, and then press the button again.
3. Press the W arrow button to select the desired paper tray (2 or 3) size, and then press the button.
4. Use the UP/DOWN arrow buttons to select
CUSTOM
, and then press the button.
5. Use the UP/DOWN arrow buttons to select INCHES , and then press the button.
6. Use the numeric keypad to enter the X-DIMENSION value (7.17 for forward IRDs, 7.80 for return IRDs), and
then press the button.
7. Use the numeric keypad to enter the
Y-DIMENSION
value (8.50 for both forward and return IRDs), and then
press the button.