M&C TechGroup BA-P4 Operator's manual - Manual (Page 21)

21
Gas sampling and conditioning technology 10-1.1-ME
The inner seals can be removed with a pointed tool (e.g. marking tool).
When refitting, the outer seals must be slipped over the cartridge into the respective seal groove.
The inner seals must be fitted as follows:

Place the seal in the adapter opening.

Push the O-ring with a blunt object on to the respective seal groove.
N O T E !
Refit the O-ring seals with care:
Do not damage O-rings and observe correct position of the seals !
The two outer O-ring seals of the adsorber cartridge must be replaced as follows:

Remove the old seals

Carefully slip the new seals over the cartridge into the appropriate grooves.
N O T E !
Refit the O-ring seals with care:
Do not damage O-rings and observe correct position of the seals !
15.7 LEAK CHECK

Tightly close the combustion air outlet.

Start the combustion air conditioning unit as specified in Chapter 13.

Monitor the inlet and outlet pressure on the pressure gauges on the front panel of the combustion
air conditioning unit.
Leaks are indicated when the specified pressures are not reached.