M&C TechGroup PMA 100-L Operator's manual - Manual (Page 3)

9-3.12.1-ME M&C Products Analysentechnik GmbH
- 3 -
1. Electrical standards
The electrical standard corresponds to the safety regula–
tions concerning the low-voltage recommendation 73/23
EWG in version 93/68 EWG and the recommendation of
electromagnetic compatibility 89/336 EWG in version
93/68 EWG.
We meet the following standards:
EN 61010 part 1 / EN 50081 part 1 / EN 50082 part 1
EN 55014 / EN 60555 part 2 & 3 / EN 60335 part 1
2. Important safety informations
Please note the following basic safety procedures when
using this equipment:
• Work on electrical equipment is only to be carried
out by trained specialists as per the regulations
currently in force.
• Attention must be paid to the requirements of IEC 364
(DIN VDE 0100) when setting high-power electrical units
with nominal voltages of up to 1000 V, together with the
associated standards and stipulations.
• Check the details on the type plate to ensure that
the equipment is connected up to the correct mains
voltage.
• Protection against touching dangerously high electrical
voltages.
Before opening the equipment, it must be switched and
hold no voltages. This also applies to any external
control circuits that are connected.
• The equipment is only to be set within the permitted
range of temperatures and pressures.
• Check that the location is weatherprotected. It should
not be subject to either direct rain or moisture.
• The equipment may not be operated in an area at
risk from explosion.
• Installation, maintenance, monitoring and any repairs
may only be done by authorised personnel with respect
to the relevant stipulations.
3. Warranty
If the equipment fails, please contact M&C directly or else
go through your M&C authorised dealer.
We offer a one year warranty as of the day of delivery as
per our normal terms and conditions of sale, and assuming
technically correct operation of the unit. Consumables are
hereby excluded. The terms of the warranty cover repair at
the factory at no cost or the replacement at no cost of the
equipment free ex user location. Reshipments must be
send in a sufficient and proper protective packaging.