M&C TechGroup SS-5_3 Operator's manual - Manual (Page 11)

11
Gas sampling and gas conditioning technology 4-3.1-ME
10 RECEIPT OF GOODS AND STORAGE
The gas conditioning and sampling system SS-5... is a completely pre-fitted unit.

Please take the gas conditioning system and possible special accessories carefully out of the
packaging material immediately after arrival, and compare the goods with the items listed on the
delivery note;

Check the goods for any damage caused during delivery and, if necessary, notify your transport
insurance company without delay of any damage discovered.
N O T E !
The equipment should be stored in a protected, frost-free room!
11 INSTALLATION INSTRUCTIONS
N O T E !
The equipment is to be used in a vertical position only. The
perfect functioning of the seperation and drainage procedures
will only be guaranteed if the equipment is used in a vertical
position.
The gas conditioning system should be installed in an area well
away from any heat emitting sources in order to prevent demage
caused by an accumulation of heat.
Pay attention to a non critical installation for individuals.
The compact gas conditioning system is preferably designed for
mounting in a cabinet. When the cabinet is installed outside,
ample protection against the effects of direct sunlight and
dampness must be provided. In winter, the equipment must only
be used in frost-free areas; Schutzart der Gasaufbereitung
beachten.
For mounting of the compact gas conditioning system the
supplied distance bolts (M5, 15mm) have to be used.
In order to guarantee the operational safety of the gas
conditioning system and the additionally connected analysers,
and to avoid false alarms, the gas conditioning system should
not be used at temperatures other than those specified.
It is of great importance that the analysers which have been
additionally connected be used at temperatures well above the
specified gas outlet dew point of +5°C. This prevents the gas in
the connector lines from condensing completely.
In the event of the unheated sample gas lines being connected to
the gas conditioning system on a slope, it is not necessary to
carry out a preliminary condensate removal.