beautypg.com

Installation facilities (accessories), Wall bracket, Figure 3 – M&C TechGroup PAS-500 Operator's manual User Manual

Page 12: Minimum dimensions for mounting resp. installation

background image

12

Gas sampling and gas conditioning technology

10-5.1-ME

15.1 INSTALLATION FACILITIES (ACCESSORIES)

The heated protective housing can be placed on the floor or on a bench (working surface). It is
important that the oven is set up accurately horizontally; the door may have to be adjusted (see
chapter 13 „Maintenance“).

W A R N I N G !



Do not place the device on a readily inflammable support surface!


The spacing from the back of the heated protective housing to the wall should be at least 15 cm. The
spacing to the ceiling must not be less than 20 cm and that at the side to the wall not less than 8 cm.
Generally it is essential to have adequate air ventilation around the housing.

Figure 3 Minimum dimensions for mounting resp. installation


15.2 WALL BRACKET

The models PAS-200 to PAS-500 can be wall-mounted using the wall bracket. The wall bracket is
factory-fitted with a fire-resistant plate. The suitable mounting material is attached to the range of
delivery.