M&C TechGroup N9 KP18 Operator's manual - Manual (Page 9)

9
Gas sampling and conditioning technology 6-1.2.1ME
8 TECHNICAL DATA
Diaphragm Pump Series N3 KPE / N3 KP18 N5 KPE / N5 KP18 N5 KPE / N5 KP18
Part Number 02P3351 / 02P3006 02P3355 / 02P3007 02P3360 / 02P3008
Max. operating pressure
0,25 bar – 3 bar abs. 0,15 – 3 bar abs. 0,15 – 1,5 bar abs.
Capacity at atm. pressure 3 Nl/min 5 Nl/min 9 Nl/min
Ambient temperature +5°C...+40°C
Sample temperature +5°C...+40°C
Storage temperature -15°C bis +60°C
Mains power supply 230V/50Hz; 115V/60Hz
Power consumption 60W
0,75A(230V)/1,5A(115V)
60W
0,65A(230V)/1,2A(115V)
Electrical connection KPE: Single wire 4x0,5mm²
KP18: wired by luster terminal
Electrical protection N3/5KPE: must be fuse-protected with 1 fuse: 230V-3,7A
T
/ 115V-
7,5A
T
N9KPE: must be fuse-protected with 1 fuse: 230V-3,15A
T
/ 115V-
6A
T
KP18: is fuse-protected with 2 fuses: 230V / 115V-3,15A
T
Preventing device Thermal switch, double (115V/230V)
Connections G 1/8“ i
DIN ISO 228/1
Protection KPE: IP00 KP18: IP20
Housing material KP18 Al-Mg-Si-0,5 / firmness: F25
Material of sample contact-
ing parts PVDF, Viton, PTFE
Weight KPE : 1,1 kg
KP18 : 1,9 kg KPE : 1,3 kg
KP18 : 2,1 kg
9
RECEIPT OF GOODS AND STORAGE

Please take the sample pump and possible special accessories carefully out of the packaging
immediately after receipt, and compare the goods with the items listed on the delivery note!

Check the goods for any damage caused during delivery and, if necessary, inform your transport
insurance company without delay of any damage discovered
N O T E !
The equipment should be stored in a protected, frost-free room!
10 INSTALLATION INSTRUCTIONS
All accident prevention regulations and safety instructions must be observed during installation and
operation. Please follow the instructions in chapter 3.