M&C TechGroup N9 KP18 Operator's manual - Manual (Page 7)

7
Gas sampling and conditioning technology 6-1.2.1ME
6 INTRODUCTION
The compact diaphragm pumps type N3/5/9 are suitable for sampling air, gases and vapours in a
temperature range between + 5 °C and + 40 °C. The construction and the pump capacity are adapted
to the requirements of the gas analysis technique.
7 APPLICATION
The sampling evacuation and compression of the diaphragm sample pump series N3/5/9 is 100% oil-
free. The operation is gas-tight and maintenance-free.
The noise level of the pump without housing is less than 55 dB(A).(pneumatically connected).
Partnumber Type Material
Pump head Diaphragm Valve Sealing
02P3351 N 3 KPE PVDF PTFE-beschichtet Viton Viton
02P3006 N 3 KP18
02P3355 N 5 KPE
02P3007 N 5 KP18
02P3360 N 9 KPE
02P3008 N 9 KP18
Material abbreviations according to ISO 1629 and 1043.1
Table 1
Pump materials
N O T E !
The diaphragm pumps series N 3/5/9 are not applicable for sam-
pling liquids.
Before use please check the compatibility of the material (see table
1).
7.1 AMBIENT CONDITIONS
When the pump is operating the following ambient conditions must be maintained:

Ambient temperature during operating: + 5°C .... + 40°C.

The pump must be protected from the effects of dust and water.

During operating an adequate supply of air for cooling must be provided.
W A R N I N G !
The pumps series N 3/5/9 are not allowed to be used in hazardous
areas.