M&C TechGroup SP10 Operator's manual - Manual (Page 11)

11
Gas sampling and gas conditioning technology 2-0.1.1-ME
N O T E !
If a PTFE tube is used as sample line, an insert must be installed in
the end of the tube in order to prevent the tube being pressed to-
gether !
Now place the heat conductivity shells on the connection of the gas sample line and prove it’s fit to
prevent cold spots.
14 ELECTRICAL CONNECTIONS
For the electrical installation take the relevant safety instructions into consideration. Before connecting
the probe ensure that the mains is voltage-free.
W A R N I N G !
When connecting the equipment, please ensure that the supply
voltage is identical with the information provided on the model type
plate!
N O T E !
Attention must be paid to the requirements of IEC 364 (DIN VDE
0100) when setting high-power electrical units with nominal volt-
ages of up to 1000 V, together with the associated standards and
stipulations!
The junction box is mounted on the side of the gas sample probe. The wiring plan is located in the lid
of the junction box. A cable bushing is available for the mains cable.