EVS XTnano Version 11.02 - July 2013 Configuration Manual - Manual (Page 65)

• The secondary links of the V3X boards correspond to the middle connectors of a
codec module:
◦ J5 for IN connectors (only IN 1B to 3B on old rear panels)
◦ J3 for OUT connectors (only OUT 1B and 2B on old rear panels)
Rear panels in 2013
Rear panels before 2013
Channel Assignment in XREC Configurations
With V3X boards, the XREC configurations should be cabled in the following sequence:
1. Cable the play channels from left to right.
2. Cable the record channels from right to left starting with the primary links, without
using the left codec modules already cabled as play channels.
3. Cable the remaining record channels to assign starting from right to left, and using the
secondary link for the remaining codec modules.
CONFIGURATION MANUAL XTnano Server 11.02
3. Multicam Configuration 57