EVS XTnano Version 11.02 - July 2013 Configuration Manual - Manual (Page 59)

3.1.6. Required Application Reboot
Introduction
Modifications to some parameters will only be applied after rebooting the application.
When you change one of the following parameters, a message will inform you that you
need to reboot Multicam.
Such parameters are summarized below, but the parameter description also specifies
when a reboot is required:
Tab Name Setting Name
Server tab Some video and reference settings:
• Field rate
• Resolution
• LTC timecode
Server tab All codec settings
Server tab All PC LAN settings (only editable from the Multicam Setup window)
Channels tab Some base settings:
• Inputs
• Outputs
• Base config
Channels tab One audio setting:
• Number of tracks
Channels tab One recorder setting:
• Loop % (in IN1 XX% Loop field)
Network tab All Gigabit settings:
• Gigabit connection
• Gigabit IP configuration
• Gigabit prioritization
Monitoring tab One setting in the Downconverted Outputs area:
• Char OUT J4
• OUT B J3
• Aspect ratio
CONFIGURATION MANUAL XTnano Server 11.02
3. Multicam Configuration 51