EVS XTnano Version 11.02 - July 2013 Configuration Manual - Manual (Page 180)

Push Target 1 / 2
Description Specifies to which machine(s) on the network the clips must
automatically be sent when the operator uses the PUSH
function on the LSM Remote Panel.
The machines defined in this setting are also used as default
target for clip copies.
The users can define two default targets: Target 1/ Target 2.
The clips will be pushed in sequential order.
Values A list of values will be displayed depending on the value
assigned to the Target setting:
• --------:
When no target is defined in these parameters, the user will
be able to define the requested target when (s)he calls the
PUSH function.
• are listed and can
be assigned for targets belonging on the GigE network.
Default Values -------- (No target machine specified)
Push Mode
Description Specifies how the clips should be sent using the PUSH
function, that is to say with or without the original guardbands.
Values The following values are possible:
• Short:
The clips are sent from the Short IN to the Short OUT
points, to which the guardbands of the destination machine
are added.
• Long:
The clips are sent from the Protect IN to the Protect OUT.
Default Values Short
Push Receive Page
Description Specifies the page of your machine where clips sent to you by
other network operators using the PUSH function must be
stored.
See section "Navigating and Editing in the Multicam
Configuration Window" on page 46 for more information on
how to enable pages
Values Page 1 to 10 (=0). Several pages can be selected.
Default Values (Page) 5
172 3. Multicam Configuration
EVS Broadcast Equipment S.A. Issue 11.02.A July 2013