EVS XTnano Version 11.02 - July 2013 Configuration Manual - Manual (Page 105)

Mode
Description Specifies how the control on the given play or record channel is
managed between the main and secondary controllers, when it
is possible to define main and secondary controllers.
Values Two control modes are possible:
• Exclusive mode:
The main controller can decide at any time to pass the
control to, or to retrieve the control from the secondary
controller.
• Parallel mode:
Any of both controllers can take the control as long as the
other controller is not executing a command. The control
can thus be freely passed on from one controller to the
other.
OSD
Description Specifies which device (main or secondary controller) will
manage the OSD display characters in parallel mode.
Values Two values are possible:
• Main: The OSD display is managed by the main controller.
• Sec.: The OSD display is managed by the secondary
controller.
Rules for Controller Assignment
Main Rules for XTnano server
On an XTnano server, the following main rules are applicable:
• In a SportLight base configuration:
◦ All Remote Panels must be the first in the list of main controllers, without gap. It is
not allowed to have another controller preceding a Remote Panel in this list.
◦ Other controllers can be assigned as secondary controllers to PGMs taking into
account the protocol-specific rules.
◦ No more than 4 play channels on an EVS server can be assigned to Remote
Panels, and no more than 3 play channels can be assigned to one Remote Panel.
◦ Only a Remote Panel (no other controller) can be assigned to a REC channel as a
main controller.
◦ No secondary controller can be assigned to a REC channel.
CONFIGURATION MANUAL XTnano Server 11.02
3. Multicam Configuration 97