EVS IPClipLogger Version 6.15 - April 2013 User Manual - Manual (Page 72)

8. Creating a Clip
8.1. Introduction
It is not possible to log a live train. Logs can only be added to a clip.
As soon as a media has been loaded, users can create a new clip from this loaded media
thanks to the clip creation functions of the Clip Infos pane. A clip can be created from a
record train loaded on a Live session tab or on the Player Session tab, or it can be created
from a recording ingest or a clip loaded on the Player Session tab. An existing clip can be
re-trimmed on the Player pane, if it has not been protected.
To speed up the logging process on a train, IPClipLogger allows the users to create logs
without setting the IN and OUT points of a clip. In this case, the system automatically
creates the IN and OUT points of the clip based on the timecodes of the first and the last
logs.
Clips are sent to a bin set as the Work bin as soon as they are saved. So, a Work bin must
have been defined prior to save a clip. See section "Managing Work Bin" on page 63.
8.2. Clip Creation Buttons and Shortcuts
The following table gives the meaning of each clip creation operation. A button and/or a
keyboard shortcut can be used to perform each action. The ShuttlePRO device has
buttons dedicated to most of these functions as well.
64 8. Creating a Clip
EVS Broadcast Equipment S.A. - April 2013 Issue 06.15.B