EVS Xfile Version 2.19 - November 2012 User Manual - Manual (Page 23)

XFile Version 2.19 – User Manual
EVS Broadcast Equipment – November 2012
Issue 2.19.A
13
3.2.1 System Configuration Area
This field displays the current parameters of the system. Some relevant parameters are
required to connect to the XNet.
If an error message is displayed facing one of the parameters, click on the System
Config button to enter the System configuration window.
If the values are coherent, click START: the System Config area is replaced by the
Session Config area:
3.2.2 Status Area
The aim of this area is to check the hardware validity, the remaining capacity of disks and
to verify the compatibility between the software, the drivers and the data recorded.
The system automatically starts the test processing. One after the other, the different
stages of the boot sequence are displayed in the Status window.
If an error occurs during one stage, write the message down and contact EVS staff for
support.
The last test is the connection to the XNet.