Garmin GPSMAP 295 - Manual (Page 86)

76
MENU
Select the ‘SYSTEM’ tab to select between Aviation Mode
and Land Mode. To change this setting, select the USAGE
MODE field, press ENTER and select the desired mode from
the pop-up window.
If TIME ZONE is set to ‘Other’, a UTC OFFSET field will
appear, allowing you to enter the difference between UTC
(zulu) time and your local time zone.
Main Menu: System
The ‘SYSTEM’ file tab provides the following settings/information:
• USAGE MODE—selects between Aviation and Land modes (see page 6).
• BEEPER—internal beeper sounds when a key is pressed, when a message is provided, or is off.
• TIME FORMAT—displays current time in a 12-hour (AM/PM) or 24-hour format.
• TIME ZONE—selects the correct time zone for display of local time.
• DAYLIGHT SAVINGS—selects between Auto detection or Daylight Savings time on/off.
• DATE/TIME (information only)—displays current date based upon Time Format, Time Zone and
Daylight Savings settings.
• BATTERY—selects Alkaline or NiCad battery type for proper display of battery level (see page 9).
• WAAS—enables/disables Wide Area Augmentation System satellite reception for improved
position accuracy (see Appendix B).
• SOFTWARE VERSION (information only)—displays the version number of the Operating
Software.
To change system settings:
1. Press MENU twice to display the Main Menu, then use the ROCKER KEYPAD to select the
‘SYSTEM’ file tab.
2. Use the ROCKER KEYPAD to select the desired field and press ENTER. A pop-up window will
show the available settings for the selected field.
3. Use the ROCKER KEYPAD to select the desired setting and press ENTER.
4. If ‘Other’ is selected for the TIME ZONE setting, a ‘UTC OFFSET’ field will appear. Select this field,
press ENTER and use the ROCKER KEYPAD enter the difference between UTC (zulu) time and
your local time. Press ENTER once all figures for the UTC OFFSET have been entered.