Acura 2011 RL - Manual (Page 87)

With the multi-information display
and the INFO (
/ ) and SEL/
RESET buttons on the right side of
the steering wheel, you can
customize some vehicle control
settings for ‘‘DRIVER 1’’ or
‘‘DRIVER 2’’. If ‘‘DRIVER 1’’ or
‘‘DRIVER 2’’ is not displayed,
customizing is not possible.
To have the driver’s ID detected,
make sure your remote is linked to
the system (see
on page ). Then use your
remote to unlock the doors (see
on page
).
To enter the customizing mode,
press and hold the INFO (
/ )
button for more than 3 seconds while
the multi-information display is in its
normal mode.
If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, or move the shift lever out
of Park, the display will change to
the normal screen.
When the multi-information
display does not show the driver’s
ID.
The first customizing menu is:
CHG SETTING (see page )
If you disconnect the battery, and
then do not unlock the door.
DEFAULT ALL (see page )
You cannot customize the settings
under these conditions:
To change the settings, the ignition
switch must be in the ON (II)
position, and the vehicle must be
stopped with the transmission in
Park.
Refer to the following table for a
brief summary of each customizable
setting and its default. For more
information, refer to the page
number references in the table.
When the driving memory settings
are off (see page
).
104
108
87
85 174
CONTINUED
Customized Settings
Memory Position
Link
Keyless Access Setup
Multi-Information Display
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
81
DRIVER’S ID
10/08/04 18:56:11 31SJA660_086