Acura 2011 RL - Manual (Page 301)

Interface Dial Feedback
On
Auto
(default)
No
The system always
reads what you select.
The system reads your
selection only while
the vehicle is moving.
The system does not
read your selection.
Clock Adjustment
Changing this setting allows you to
control when (and if) the system will
read the current selection you
choose with the interface dial. This
feature can minimize the need to
look at the screen while operating
the dial. The three settings are
explained in the following table. The
factory default setting is
.
You can adjust the clock of your
system. When the battery is
disconnected or the fuse for the
compass system is removed, you
need to reset the time. See page
for more information on setting
the clock.
The second setup screen allows you
to change the system’s voice
recognition feedback, auto volume
for speed, and clock settings. To
select a setup item, turn the interface
knob until it is highlighted, then
press ENTER to select it.
313
CONTINUED
AUTO
Setting Feedback Level
Second Set up Screen
Compass System (U.S. model without navigation system)
Fe
a
tu
re
s
295
10/08/04 19:32:45 31SJA660_300