Acura 2011 RL - Manual (Page 180)

The driving position memory
activated (Driver 1, Driver 2) is
shown on the back of each remote.
Make sure you store your desired
driving position in the memory that
is activated by the remote you
normally carry.
When you unlock the driver’s door
with your remote transmitter, each
remote transmitter activates the
customized settings related to that
remote.
To turn off this feature, press and
hold the LOCK and UNLOCK
buttons at the same time. The LED
in the remote will blink once. Then
release the buttons. Doing this
cancels the keyless memory settings
for that remote and restores the
default settings.
Some of them keep the same
settings as they were set previously.
To turn the keyless memory settings
back on, repeat this procedure. The
LED will blink twice to indicate the
feature has been turned on.
When you unlock and open the
driver’s door with the remote, the
driver’s seat (except power lumbar)
and outside mirrors move to the
positions stored in memory. An
indicator on one of the driving
position memory buttons on the
driver’s door also comes on.
Navigation system preferences
(see the navigation system
manual).
Here are the settings activated with
the remote:
Driving position memory
(see page
).
Customized settings
(see page
).
Audio system settings
(see page
).
Climate control settings
(see page
).
Compass system preferences
(see page
).
164
81
213
205
281
U.S. RL model
Except U.S. RL model
Keyless Access System
Recalling a Memorized Driving
Position
174
DRIVER’S ID
10/08/04 19:11:27 31SJA660_179