Acura 2011 RL - Manual (Page 176)

Each front door has a LOCK/
UNLOCK feature.
When you touch the door lock
sensor of the front door by hand, all
the doors and the trunk will lock.
The lock sensors do not operate if:
When you lock the doors, some
exterior lights blink once and the
system beeps once. When you
cannot set the security system
because the trunk or hood is open,
no exterior light blinks and/or no
beeper sounds.
Before locking the doors, make sure
the remote is not inside the vehicle. If a remote is within operating range
while you wash your vehicle or when
it is raining heavily, the door sensors
may respond by locking the doors.
Within 2 seconds of touching the
handle to lock the doors or locking
the doors with remote, pull the
handle to make sure the doors are
actually locked. The door unlock
sensors do not operate for about 2
seconds after the doors are locked.
To change the ‘‘KEYLESS ACCESS
BEEP’’ setting, see page
.
To change the ‘‘KEYLESS ACCESS
LIGHT FLASH’’ setting, see page
.
If you touch the door lock sensor of
the front door with your hand
wearing a glove, the door sensor may
delay to respond or not respond by
locking the doors.
The remote is not within the
operating range.
The doors are open.
The ignition switch is not in the
LOCK (0) position.
The built-in key is in the ignition
switch.
The remote is too close to the
vehicle.
The remote battery is dead.
The vehicle battery is dead.
111
113
Locking the Doors
Keyless Access System
170
DOOR LOCK SENSOR
10/08/04 19:10:34 31SJA660_175