Acura 2011 RL - Manual (Page 311)

If the system does not understand a
command or you wait too long to
give a command, it responds with
‘‘Pardon,’’ ‘‘Please repeat,’’ or ‘‘Would
you say again.’’ If the system cannot
perform a command or the
command is not appropriate for the
screen you are on, it sounds a beep.
Anytime you are not sure of what
voice commands are available on a
screen, you can always say ‘‘Help’’ at
any screen. The system can then
read the list of commands to you.
You should use the voice control
system as much as possible, and
consider manual entry using the
as a ‘‘back-up’’
method of entry.
Most of the system’s functions can
be controlled by voice commands
activated with the
button. To
control your compass system by
voice:
Press and release the button.
Wait for the beep.
Give a voice command.
Once the microphone picks up your
command, the system changes the
display in response to the command
and prompts you for the next
command. Using the
button,
answer the prompts as required.
This button activates the voice
control system. Press it when you
want to give a voice command. See
on page for
a list of voice commands.
This button has the same function as
the CANCEL button on the center
console (see page
). When you
press it, the display returns to the
previous screen. When the previous
screen appears, the system replays
the last prompt. This button can be
used to cancel an audio, climate
control, or compass system voice
command up to one second after the
command confirmation.
307
282
Voice Command Index
CONTINUED
Compass System (U.S. model without navigation system)
Using the Voice Control System
interf ace dial
Talk
Talk
Talk
Talk Button
Back Button
Fe
a
tu
re
s
305
10/08/04 19:34:27 31SJA660_310