Acura 2011 RL - Manual (Page 183)

If the ignition switch cannot be
turned from the LOCK (0) position
to the ACCESSORY (I) position after
the beep, the steering wheel is
locked. To unlock the steering wheel,
turn it right and left while turning
the ignition switch at the same time.
If the remote and the vehicle do not
recognize each other, turn the
ignition switch to the LOCK (0)
position, remove the ignition switch
cover, insert the built-in key, and
turn the switch (see pages
and
).
When you push the ignition switch,
the remote and the vehicle recognize
each other. After the recognition,
the remote indicator flashes, and a
beeper sounds once. After the beep,
turn the ignition switch.
When the remote is out of the
operating range, the ignition switch
is locked.
151
178
CONTINUED
Ignition Switch
Keyless Access System
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
177
Make sure you know where the remote
is when you are inside the vehicle.
Remember that you can start the engine
without using the built-in key when the
remote is inside the vehicle.
Make sure you always carry the remote
with you.
10/08/04 19:12:02 31SJA660_182