Acura 2011 RL - Manual (Page 430)

When the VSA system indicator
comes on (see page
).
The CMBS indicator normally comes
on under these conditions:
When you manually switch off the
system.
When the system shuts off
automatically.
When you drive in bad weather
(rain, snow, fog, etc.).
If anything covers the radar
sensor cover (dirt, mud, dry leaves,
wet snow, etc.).
The CMBS will automatically switch
on again if the conditions that caused
it to switch off are improved.
This indicator comes on for several
seconds when you turn the ignition
switch to the ON (II) position. It also
comes on and stays on when you
turn the CMBS off by pressing the
CMBS OFF button.
To switch the CMBS back on, make
sure the vehicle is stopped and the
ignition switch is in the ON (II)
position, then press the CMBS OFF
button for about 1 second.
435
CMBS Indicator
Collision Mitigation Braking System (CMBS )
424
CMBS INDICATOR
TM TM
10/08/04 19:56:15 31SJA660_429