1 copy/sync button, 2 reset button, 1 copy/sync button 1.4.2 reset button – ZyXEL Communications NSA210 User Manual
Page 27
Chapter 1 Getting to Know Your NSA
NSA210 User’s Guide
27
1.4.1 COPY/SYNC Button
Use the COPY/SYNC button on the front panel to copy or synchronize files
between a connected USB device and the NSA. See
for
more details on how to configure the copy/sync settings.
1.4.2 RESET Button
Use the RESET button on the rear panel to restore the NSA’s default settings.
Figure 4 The RESET Button
• Press the RESET button until you hear one beep (after about two seconds),
then release it. You will hear one more beep after you release the button.
This resets the NSA’s IP address and password to the default values.
USB
Green
On
The hard disk drive is connected properly to the NSA.
Blinking
The NSA is saving data to the hard disk drive.
Red
On
The hard disk drive has failed and the NSA can no longer
detect it.
Off
No USB device connected to the USB port.
eSATA
Green
On
The hard disk drive is connected properly to the NSA.
Blinking
The NSA is saving data to the hard disk drive.
Red
On
The hard disk drive has failed and the NSA can no longer
detect it.
Off
No eSATA hard disk connected to the eSATA port.
COPY
Green
On
A USB device is connected to the NSA.
Blinking
The NSA is copying or synchronizing files to or from the
USB device.
Red
On
Copying or synchronizing files to or from the USB device
failed.
Off
No USB device is connected.
Table 1 LEDs (continued)
LED
COLOR
STATUS DESCRIPTION
Press
1 Beep
2 Beeps
IP Address
Password
Clear All Settings
5 more seconds
Release to
Release to Reset