Xerox 600 - Manual (Page 23)

Connecting the power cord
Follow these steps to connect the power cord to the scanner:
1 Align the holes in the socket end of the power cord with the pins of the power cord
socket on the back of the scanner.
2 Plug the socket end of the power cord into the pins on the scanner.
3 Plug the other end of the power cord into a standard electrical outlet that accepts a
three-pronged plug.
You’re now ready to switch the scanner on and install the scanner software.
Power cord plug
WARNING This equipment is intended to be electrically grounded. Your
Apple Color OneScanner is equipped with a three-wire grounding
plug—a plug that has a third (grounding) pin. This plug will fit only a
grounded AC outlet. This is a safety feature. If you are unable to insert
the plug into the outlet, contact a licensed electrician to replace the
outlet with a properly grounded outlet. Do not defeat the purpose of the
grounding plug!
15 Setting Up the Scanner