beautypg.com

Configure pptp client, Pppoe encapsulation, Configure pptp client -11 – ZyXEL Communications Prestige 310 User Manual

Page 53: Pppoe encapsulation -11, Figure 3-7, Internet access setup (pptp) -11, Table 3-5, New fields in menu 4 (pptp) screen -11, 3 configure pptp client, 4 pppoe encapsulation

background image

Prestige 310 Broadband Sharing Gateway

Internet Access

3-11

3.3.3 Configure PPTP Client

To configure a PPTP client, you must configure My Login and Password fields for PPP connection and
PPTP parameters for PPTP connection.

After configuring the User Name and Password for PPP connection, toggle the space bar in the
Encapsulation field in Menu 4 -Internet Access Setup to choose PPTP as your encapsulation option.
If you choose PPTP in Menu 4 you will see the next screen.

Figure 3-7

Internet Access Setup (PPTP)

The following table contains instructions about the new fields when you choose PPTP in the Encapsulation
field in Menu 4.

Table 3-5

New Fields in Menu 4 (PPTP) screen

Field

Description

Examples

Encapsulation

Press the [SPACE BAR] and then press [ENTER] to choose
PPTP. The encapsulation method influences your choices for
IP Address.

PPTP

Idle Timeout

This value specifies the time in seconds that elapses before
the Prestige automatically disconnects from the PPTP server.

100

(default)

3.3.4 PPPoE

Encapsulation

The Prestige supports PPPoE (Point-to-Point Protocol over Ethernet). You can use PPPoE encapsulation only
when you’re using the Prestige with an xDSL modem as the WAN device.
PPPoE is an IETF Draft standard specifying how a host personal computer (PC) interacts with a broadband
modem (i.e. xDSL, cable, wireless, etc.) to achieve access to high-speed data networks. It preserves the
existing Microsoft Dial-Up Networking experience and requires no new learning or procedures.

Menu 4 - Internet Access Setup

ISP's Name= ChangeMe
Encapsulation= PPTP
Service Type= N/A
My Login= username

My Password= ******
Idle Timeout= 100

IP Address Assignment= Dynamic

IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Address=N/A

Single User Account= Yes

Press ENTER to Confirm or ESC to Cancel: