ZyXEL Communications Prestige 310 - Manual (Page 104)

Prestige 310 Broadband Sharing Gateway
System Information & Diagnosis 9-2
9.1 System Status
The first selection, System Status, gives you information on the version of your system firmware and the
status and statistics of the ports, as shown in the figure below. System Status is a tool that can be used to
monitor your Prestige. Specifically, it gives you information on your system firmware version, number of
packets sent and number of packets received.
To get to the System Status:
Step 1.
Enter number 24 to go to Menu 24 - System Maintenance.
Step 2. In this menu, enter number 1 to open System Maintenance - Status.
Step 3. There are three commands in Menu 24.1 - System Maintenance - Status. Entering 1 drops the
WAN (PPTP/PPPoE) connection, 9 resets the counters and [Esc] takes you back to the previous
screen.
The table below describes the fields present in Menu 24.1 - System Maintenance - Status. It should be
noted that these fields are READ-ONLY and are meant to be used for diagnostic purposes.
Figure 9-2 Menu 24.1 - System Maintenance – Status
Menu 24.1 -- System Maintenance – Status
1:39:06
Thus. Jan. 1. 1970
Port
WAN
LAN
Status
Down
Down TxPkts
1
0
RxPkts
0
0
Cols
0
0
Tx B/s
0
0
Rx B/s
0
0
Up Time
0:00:00
0:00:00
Port:
WAN
LAN
Ethernet Address
00:a0:c5:21:8c:a3
00:a0:c5:21:8c:a2 IP Address
0.0.0.0
192.168.1.1 IP Mask
0.0.0.0
255.255.255.0
DHCP
Client
Server
System up Time: 1:08:22
Name: P310.www.zyxel.com
Routing: IP
ZyNOS F/W Version: V.251 : 2/17/2000
Press Command:
COMMANDS: 1-Drop WAN 9-Reset Counters ESC-Exit