ZyXEL Communications P-870MH-C1 - Manual (Page 58)

Chapter 9 vlanQoS Commands
P-870MH-C1 User’s Guide
58
Run the vlanQoS save command to save this change to non-volatile memory. See Section
6.4 on page 48 for examples of this command.
9.3 vlanQoS clear
Syntax:
vlanQoS clear [|]
Parameter(s):
Use this command to reset port-based VLAN settings and/or IEEE 802.1Q settings to their
default values. For port-based VLAN settings, you can reset a specific port or all ports. For
IEEE 802.1Q settings, you can reset a specific VLAN or all VLANs.
Run the vlanQoS save command to save this change to non-volatile memory. See
Section
6.3 on page 47 and Section 6.4 on page 48 for examples of this command.
9.4 vlanQoS disp
Syntax:
vlanQoS disp
Use this command to display the current settings for port-based VLAN or IEEE 802.1Q
VLAN (whichever one is active) and for QoS. For IEEE 802.1Q VLAN, forbidden ports are
indicated by a blank value or an F.
Run the vlanQoS save command to save this change to non-volatile memory. See
Section
6.3 on page 47 , Section 6.4 on page 48 , and Section 6.5 on page 50 for examples of this
command.
9.5 vlanQoS modechane
Syntax:
vlanQoS modechane <0|1>
Parameter(s):
= Specifies which settings you want to clear.
p|P: Port-based VLAN settings and QoS settings
1: IEEE 802.1Q settings
a|A: All port-based VLAN settings, IEEE 802.1Q settings, and QoS
settings
= Specifies the item number of the VLAN. See the vlanQoS 1qset
command for more information about the item number. You can
only use this parameter if you clear IEEE 802.1Q settings (option
1)
= Specifies the port number <1..5>. Port 5 is the DSL port. You can
only use this parameter if you clear port-based VLAN settings
(options p or P).
<0|1> = Specifies whether the P-870MH-C1 uses port-based VLAN (0) or
IEEE 802.1Q VLAN (1).