ZyXEL Communications P-870MH-C1 - Manual (Page 48)

Chapter 6 ip Commands
P-870MH-C1 User’s Guide
48
Figure 32 Display Current Statistics for IGMP Snooping
6.10 ip ping
Syntax:
ip ping
Parameter(s):
Use this command to ping a device on the network. You can use this command to test the
network connection between the P-870MH-C1 and the device with the specified IP address.
See
Section 6.2 on page 46 for examples of this command.
6.11 ip tcp status
Syntax:
ip tcp status
Use this command to look at TCP packet statistics and TCP sockets on the P-870MH-C1.
Figure 33 Example: ip tcp status
6.12 ip udp status
Syntax:
ip udp status
Use this command to look at UDP packet statistics and UDP sockets on the P-870MH-C1.
ras> ip igmpsnp disp
IGMP Snooping is: Disabled
group count: 0
MaxResponseTime=20, QueryInterval=25, Robustness=20
--------------------------------------------------------
GroupID LANGroup To TimeOut
--------------------------------------------------------
= Specifies the IP address of the device you want the P-870MH-C1
to ping.
ras> ip tcp status
( 1)tcpRtoAlgorithm 4 ( 2)tcpRtoMin 0
( 3)tcpRtoMax 4294967295 ( 4)tcpMaxConn 4294967295
( 5)tcpActiveOpens 0 ( 6)tcpPassiveOpens 1
( 7)tcpAttemptFails 0 ( 8)tcpEstabResets 0
( 9)tcpCurrEstab 1 (10)tcpInSegs 562
(11)tcpOutSegs 672 (12)tcpRetransSegs 0
(14)tcpInErrs 0 (15)tcpOutRsts 0
&TCB Rcv-Q Snd-Q Local socket Remote socket State
802f5024 0 602 192.168.1.2:23 192.168.1.34:1406 Estab
802f5138 0 0 0.0.0.0:21 0.0.0.0:0 Listen