ZyXEL Communications P-870MH-C1 - Manual (Page 45)

P-870MH-C1 User’s Guide
45
C
H A P T E R
6
ip Commands
This chapter introduces the basic ip commands.
6.1 ip address
Syntax:
ip address []
Parameter(s):
Use this command to look or set the management IP address of the P-870MH-C1. This IP
address is the same one you use to access the P-870MH-C1. If you change this IP address, you
have to log in to the P-870MH-C1 again.
6.2 ip arp status
Syntax:
ip arp status
Use this command to look at the ARP table and ARP statistics for the P-870MH-C1.
Figure 28 Example: ip arp status
6.3 ip igmpsnp disable
Syntax:
ip igmpsnp disable
Use this command to disable IGMP snooping. See Section 6.6 on page 51 for examples of this
command.
= Specifies the new management IP address of the P-870MH-C1.
ras> ip arp status
received 569 badtype 0 bogus addr 0 reqst in 0 replies 1 reqst out 1
cache hit 168 (98%), cache miss 3 (1%)
IP-addr Type Time Addr stat iface
192.168.1.34 10 Mb Ethernet 270 00:10:B5:AE:56:9B 41 enif0
192.168.1.255 10 Mb Ethernet 0 FF:FF:FF:FF:FF:FF 43 NULL
num of arp entries= 2