ZyXEL Communications P-870MH-C1 - Manual (Page 53)

Chapter 7 sys Commands
P-870MH-C1 User’s Guide
53
Use this command to reset the P-870MH-C1 to its factory default settings. The P-870MH-C1
also reboots. Afterwards, you have to connect to the P-870MH-C1 again. See
Section 6.1 on
page 45 for examples of this command.
7.6 sys stdio
Syntax:
sys stdio [<0..3600>]
Parameter(s):
Use this command to set the idle timeout for each management session. You can also disable
the timeout by setting this value to 0. See
Section 6.1 on page 45 for examples of this
command.
7.7 sys time
Syntax:
sys time [ [ []]]
Parameter(s):
Use this command to look at or set the current time in the P-870MH-C1. If you enter the
optional parameters, the command changes the value of the setting to the specified parameter.
If you do not enter any of the parameters, the command displays the current value. If you enter
some but not all of the parameters, the P-870MH-C1 continues to use the current value for
unspecified parameters.
7.8 sys version
Syntax:
sys version
Use this command to look at information about the current firmware version.
Figure 36 Example: sys version
<0..3600> = Specifies the idle timeout, in minutes, for each management
session. Enter 0 to disable the idle timeout.
= Specifies the current hour <0..23>.
= Specifies the current minute <0..59>.
= Specifies the current second <0..59>.
ras> sys version
ZyNOS version: V3.50(RT.0)b2 | 07/13/2006
romRasSize: 1076656
system up time: 0:20:29 (1e065 ticks)
bootbase version: V1.04 | 06/23/2006
ZyNOS CODE: RAS Jul 12 2006 16:20:22
Product Model: P-870MH-C1