ZyXEL Communications P-870MH-C1 - Manual (Page 57)

P-870MH-C1 User’s Guide
57
C
H A P T E R
9
vlanQoS Commands
This chapter introduces the vlanQoS commands.
9.1 vlanQoS 1qconfig
Syntax:
vlanQoS 1qconfig [ [ [...]]]
Parameter(s):
Use this command to configure port settings for an IEEE 802.1Q VLAN. You have to use the
vlanQoS 1qset command to create the VLAN first.
Run the vlanQoS save command to save this change to non-volatile memory. See
Section
6.4 on page 48 for examples of this command.
9.2 vlanQoS 1qset
Syntax:
vlanQoS 1qset
Parameter(s):
Use this command to create a new IEEE 802.1Q VLAN in the P-870MH-C1. This VLAN
replaces any existing VLAN with the same item number. If there is no existing VLAN, all of
the ports are forbidden by default.
In the P-870MH-C1, each VLAN has an associated item number. You can look up the item
number by using the vlanQoS disp command. You can also calculate it. The item number
is the VLAN ID mod 8, or the remainder when the VLAN ID is divided by eight.
= Specifies the item number of the VLAN. See the vlanQoS 1qset
command for more information about the item number.
= Specifies what type of port the specified port(s) is(are) in the
specified VLAN.
T: Tagged port
F: Forbidden port
U: Untagged port
= Specifies the port number <1..5> of each port to which the
specified type is assigned. Port 5 is the DSL port.
= Specifies the VLAN ID.