ZyXEL Communications P-870MH-C1 - Manual (Page 46)

Chapter 6 ip Commands
P-870MH-C1 User’s Guide
46
6.4 ip igmpsnp disp
Syntax:
ip igmpsnp disp
Use this command to display the current status of IGMP snooping and to look at the multicast
groups currently passing through the P-870MH-C1. See
Section 6.6 on page 51 for examples
of this command.
6.5 ip igmpsnp enable
Syntax:
ip igmpsnp enable
Use this command to enable IGMP snooping. See Section 6.6 on page 51 for examples of this
command.
6.6 ip igmpsnp maxresptime
Syntax:
ip igmpsnp maxresptime [<0..255>]
Parameter(s):
Use this command to look at or set the maximum response time for IGMP snooping. You have
to use this command when IGMP snooping is disabled. You cannot use this command when
IGMP snooping is enabled. See
Section 6.6 on page 51 for examples of this command.
6.7 ip igmpsnp queryinterval
Syntax:
ip igmpsnp queryinterval [<0..255>]
Parameter(s):
Use this command to look at or set the query interval for IGMP snooping. You have to use this
command when IGMP snooping is disabled. You cannot use this command when IGMP
snooping is enabled. See
Section 6.6 on page 51 for examples of this command.
6.8 ip igmpsnp robust
Syntax:
ip igmpsnp robust [<0..255>]
Parameter(s):
<0..255> = Specifies the maximum response time for IGMP snooping.
<0..255> = Specifies the query interval for IGMP snooping.
<0..255> = Specifies the robustness setting for IGMP snooping.