ZyXEL Communications ZyXEL ZyAIR B-1000 - Manual (Page 167)

ZyAIR Access Point Series User’s Guide
System Maintenance and Information 20-1
Chapter 20
System Maintenance and Information
This chapter leads you through SMT menus 24.8 and 24.10.
20.1 Command Interpreter Mode
The Command Interpreter (CI) is a part of the main system firmware. The CI provides much of the same
functionality as the SMT, while adding some low-level setup and diagnostic functions. Enter the CI from
the SMT by selecting menu 24.8. See the included disk or the zyxel.com web site for more detailed
information on CI commands. Enter 8 from Menu 24 – System Maintenance. A list of valid commands
can be found by typing help or ? at the command prompt. Type “exit” to return to the SMT main menu
when finished.
Figure 20-1 Menu 24 System Maintenance
Figure 20-2 Valid CI Commands
Menu 24 – System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Upload Firmware
8. Command Interpreter Mode
10. Time and Date Setting
Enter Menu Selection Number:
Copyright (c) 1994 - 2003 ZyXEL Communications Corp.
B-3000> ?
Valid commands are:
sys exit device ether
config wlan ip ppp
bridge hdap radius 8021x
B-3000>