ZyXEL Communications ZyXEL ZyAIR B-1000 - Manual (Page 127)

ZyAIR Access Point Series User’s Guide
LAN Setup 13-3
Figure 13-3 Menu 3.5 Wireless LAN Setup
The following table describes the fields in this menu.
Table 13-2 Menu 3.5 Wireless LAN Setup
FIELD DESCRIPTION EXMAPLE
Operating
Mode Press [SPACE BAR] and select Access Point, Multiple ESS or Bridge.
This field is not available on all models. Access
Point
ESSID The ESSID (Extended Service Set IDentity) identifies the AP the wireless
station is to associate to. Wireless stations associating to the AP must have
the same ESSID. Enter a descriptive name up to 32 printable 7-bit ASCII
characters.
This field is only available when you select Access Point in the Operating
Mode field. Wireless
Hide ESSID Press [SPACE BAR] and select Yes to hide the ESSID in the outgoing data
frame so an intruder cannot obtain the ESSID through passive scanning. No
Channel ID Press [SPACE BAR] to select a channel. This allows you to set the operating
frequency/channel depending on your particular region. CH01
2412MHz
RTS
Threshold Setting this attribute to zero turns on the RTS/CTS handshake. Enter a value
between 0 and 2432. 2432
Frag.
Threshold This is the maximum data fragment size that can be sent. Enter a value
between 256 and 2432. 2432
Menu 3.5 - Wireless LAN Setup
Operating Mode= Access Point Edit MAC Address Filter= No
ESSID= Wireless Edit Roaming Configuration= No
Hide ESSID= No Edit Multiple ESS Configuration= N/A
Channel ID= CH01 2412MHz Edit Bridge Link Configuration= N/A
RTS Threshold= 2432 Block Intra-BSS Traffic= No
Frag. Threshold= 2432 Number of Associated Stations= 32
WEP Encryption= Disable Breathing LED= Yes
Default Key= N/A Output Power= 17dBm
Key1= N/A
Key2= N/A
Key3= N/A
Key4= N/A
Authen. Method= N/A
Press ENTER to Confirm or ESC to Cancel: