ZyXEL Communications ZyXEL ZyAIR B-1000 - Manual (Page 143)

ZyAIR Access Point Series User’s Guide
SNMP Configuration 16-3
Figure 16-2 Menu 22 SNMP Configuration
The following table describes the SNMP configuration parameters.
Table 16-1 Menu 22 SNMP Configuration
FIELD DESCRIPTION EXAMPLE
SNMP:
Get Community Type the Get Community, which is the password for the incoming
Get- and GetNext requests from the management station. public
Set Community Type the Set Community, which is the password for incoming Set
requests from the management station. public
Trusted Host If you enter a trusted host, your ZyAIR will only respond to SNMP
messages from this address. A blank (default) field means your
ZyAIR will respond to all SNMP messages it receives, regardless
of source. 0.0.0.0
Trap:
Community Type the trap community, which is the password sent with each
trap to the SNMP manager.
public
Destination Type the IP address of the station to send your SNMP traps to. 0.0.0.0
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
16.4 SNMP Traps
The ZyAIR will send traps to the SNMP manager when any one of the following events occurs:
Menu 22 - SNMP Configuration
SNMP:
Get Community= public
Set Community= public
Trusted Host= 0.0.0.0
Trap:
Community= public
Destination= 0.0.0.0
Press ENTER to Confirm or ESC to Cancel: