ZyXEL Communications ZyXEL ZyAIR B-1000 - Manual (Page 128)

ZyAIR Access Point Series User’s Guide
13-4 LAN Setup
Table 13-2 Menu 3.5 Wireless LAN Setup
FIELD DESCRIPTION EXMAPLE
WEP
Encryption Select Disable to allow wireless stations to communicate with the access
points without any data encryption.
Select 64-bit WEP or 128-bit WEP to enable data encryption. Disable
Default Key Enter the key number (1 to 4) in this field. Only one key can be enabled at
any one time. This key must be the same on the ZyAIR and the wireless
stations to communicate. 1
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the ZyAIR and the wireless
stations must use the same WEP key for data transmission.
If you chose 64-bit WEP in the WEP Encryption field, then enter any 5
ASCII characters or 10 hexadecimal characters ("0-9", "A-F").
If you chose 128-bit WEP in the WEP Encryption field, then enter 13 ASCII
characters or 26 hexadecimal characters ("0-9", "A-F").
Enter “0x” before the key to denote a hexadecimal key.
Don’t enter “0x” before the key to denote an ASCII key.
0x12345ab
cde
Authen.
Method Press [SPACE BAR] to select Auto, Open System Only or Shared Key
Only and press [ENTER].
This field is N/A if WEP is not activated.
If WEP encryption is activated, the default setting is Auto.
Auto
Block Intra-
BSS Traffic Press [SPACE BAR] to select Yes or No and press [ENTER].
Number of
Association
Stations Enter the number of association stations. The number should be from 1 to
32.
Breathing LED Press [SPACE BAR] to select Yes or No and press [ENTER].
Output Power Press [SPACE BAR] to select 11dBm, 13dBm, 15dBm or 17dBm and press
[ENTER].
17dBm
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.