ZyXEL Communications ZyXEL ZyAIR B-1000 - Manual (Page 134)

ZyAIR Access Point Series User’s Guide
13-10 LAN Setup
Figure 13-10 Menu 3.5.3.1 ESS x Configuration
The following table describes the fields in this menu.
Table 13-6 Menu 3.5.3.1 ESS x Configuration
FIELD DESCRIPTION
ESSID Enter the descriptive name up to 32 alphanumeric characters for identification.
This field is case sensitive.
Active Press [SPACE BAR] to select Yes or No and press [ENTER].
Default Unicast
Key
Key 1 or key 2 is used to encrypt unicast transmissions.
Default Broadcast
Key
Key 3 or key 4 is used to encrypt multicast/broadcast transmissions.
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the ZyAIR and the wireless stations
must use the same WEP key for data transmission.
If you chose 64-bit WEP in the WEP Encryption field, then enter any 5 ASCII
characters or 10 hexadecimal characters ("0-9", "A-F").
If you chose 128-bit WEP in the WEP Encryption field, then enter 13 ASCII
characters or 26 hexadecimal characters ("0-9", "A-F").
Enter “0x” before the key to denote a hexadecimal key. Don’t
enter “0x” before the key to denote an ASCII key.
VLAN ID Enter a number from 1 to 255.
Menu 3.5.3.1 - ESS 1 Configuration
ESSID=
Active= No
Default Unicast Key= 1
Default Broadcast/Multicast Key= 3
Key 1= ********
Key 2= ********
Key 3= ********
Key 4= ********
VLAN ID= 0
Edit MAC Address Filter= No
Press ENTER to Confirm or ESC to Cancel: