ZyXEL Communications ZyXEL ZyAIR B-1000 User Manual
Page 132
ZyAIR Access Point Series User’s Guide
13-8
LAN Setup
Table 13-4 Menu 3.5.2 Roaming Configuration
FIELD DESCRIPTION
Active
Press [SPACE BAR] and then [ENTER] to select Yes to enable roaming on the ZyAIR if you
have two or more ZyAIRs on the same subnet.
Port #
Type the port number to communicate roaming information between access points. The port
number must be the same on all access points. The default is 16290. Make sure this port is
not used by other services.
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to confirm or ESC to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
13.3.3 Configuring Multiple ESS (for ZyAIR B-3000 only)
Follow the steps below to configure Multiple ESS on your ZyAIR.
Step 1.
From the main menu, enter 3 to open Menu 3 – LAN Setup.
Step 2.
Enter 5 to display Menu 3.5 – Wireless LAN Setup.
Figure 13-8 Menu 3.5 Wireless LAN Setup
Step 3.
In the Operating Mode field, press [SPACE BAR] to select Multiple ESS and press
[ENTER].
Step 4.
Move the cursor to the Edit Multiple ESS Configuration field. Press [SPACE BAR] to select
Yes and press [ENTER]. Menu 3.5.3 – Multiple ESS Configuration displays as shown next.
Menu 3.5 - Wireless LAN Setup
Operating Mode= Multiple ESS
Edit MAC Address Filter= N/A
ESSID= N/A Edit Roaming Configuration= No
Hide ESSID= N/A
Edit Multiple ESS Configuration= Yes
Channel ID= CH01 2412MHz Edit Bridge Link Configuration= N/A
RTS Threshold= 2432 Block Intra-BSS Traffic= No
Frag. Threshold= 2432 Number of Associated Stations= 32
WEP Encryption= N/A Breathing LED= Yes
Default Key= N/A Output Power= 17dBm
Key1= N/A
Key2= N/A
Key3= N/A
Key4= N/A
Authen. Method= N/A
Press ENTER to Confirm or ESC to Cancel: