ZyXEL Communications Prestige 100WH - Manual (Page 81)

Prestige 100WH Internet Access Router
6-5 Chapter 6 Dial-in Server Applications
Table 6-2 describes and contains information on how to configure each parameter in Menu 13
- Default Dial-in Setup.
Table 6-2. Default Dial-in Setup Fields
Field Description
Telco Options: CLID
Authen This field sets the CLID (Calling Line ID) authentication parameter for all
incoming calls. There are three options for this field:
l None - No CLID is required.
l Required – CLID MUST be available, or the Prestige will not answer
the call.
l Preferred - If the CLID is available then CLID will be used for
authentication. If the CLID is not available, authentication is done in
PPP negotiation.
PPP Options: Recv.
Authen This field sets the authentication protocol used for incoming calls. User
names and passwords are configured in the next section (Dial-in Users
Setup). Options for this field are:
l CHAP/PAP - Your Prestige will try CHAP first, but PAP will be used if
CHAP is not available.
l CHAP - Use CHAP only.
l PAP - Use PAP only.
l None - Your Prestige will try CHAP first, but no authentication is
required if CHAP is not available.
PPP Options: Mutual
Authen Some vendors (for example, Cisco) implement mutual authentication.
That is, the node that initiates the call will request a user name and
password from the far end that they are dialing to. If the remote node that
is dialing in implements this type of authentication, set this field to Yes.
PAP Login This field will only be enabled if the Mutual Authen. Field is [Yes]. Enter in
the PAP login name for this Prestige. This field does not apply to CHAP
authentication.
PAP Password This field will only be enabled if the Mutual Authen is [Yes]. Enter the PAP
password for this Prestige. This field does not apply to CHAP
authentication.