ZyXEL Communications Prestige 100WH - Manual (Page 50)

Prestige 100WH Internet Access Router
3-6 Chapter 3 Internet Access Application
Follow the instructions in Table 3-1.on how to configure the DHCP fields.
Table 3-1. DHCP Ethernet Setup Menu Fields
Field Description
DHCP
If DHCP=Server:
This field determines the mode of DHCP support. If set to [None],
DHCP will not be used. If it is set to [Server], your Prestige will
act as a DHCP server.
The default in this field is [Server].
When DHCP is used, the following four items need to be set:
Client IP Pool Starting
Address The Client IP Pool Starting Address gives the first address in the
pool.
The default in this field is 192.168.1.33
Size of Client IP Pool The count of the IP addresses in the pool.
The default in this field is 32.
Primary and Secondary
DNS Server Enter the IP address of the DNS server(s) provided by your ISP
or network administrator.
Table 3-2 contains instructions on how to configure your Prestige for TCP/IP Ethernet Setup.
Table 3-2. TCP/IP Ethernet Setup Menu Fields
Field Description
TCP/IP Setup
IP Address Enter the IP address of your Prestige in dotted decimal notation.
The default in this field is 192.168.1.1.
IP Subnet
Mask Enter the subnet mask of your Prestige.
The default in this field is 255.255.255.0.
RIP
Direction This parameter determines how your Prestige handles RIP traffic
(In/Out/both/none).
The default in this field is [Both].
Version Version of RIP packets sent by the Prestige. The default in this field is RIP-1.
When you have completed this menu, press [Enter] at the prompt [Press ENTER to Confirm…] to
save your configuration, or press [Esc] at any time to cancel.