ZyXEL Communications Prestige 100WH - Manual (Page 76)

Prestige 100WH Internet Access Router
5-8 Chapter 5 Remote Node TCP/IP Configuration
Table 5-2 describes the fields for Menu 12.1 - Edit IP Static Route Setup.
Table 5-2. Edit IP Static Route Menu Fields
Field Description
Route Name Enter a descriptive name for this route. This is for identification purpose
only.
Active This field allows you to activate/deactivate this static route.
Destination IP Address This parameter specifies the IP address of the remote network.
IP Subnet Mask Enter the subnet mask for this destination. Follow the discussion on IP
subnet mask in this chapter. If you need to specify a route to a single hose,
use a subnet mask of 255.255.255.255 in this field.
Gateway IP Address Enter the IP address of the gateway. The gateway is an immediate
neighbor of your Prestige that will forward the packet to the destination. On
the LAN, the gateway must be a router on the same segment as your
Prestige; over WAN, the gateway must be the IP address of one of the
Remote nodes.
Metric Same meaning as those in the Remote node Setup (See Table 5-1).
Private Same meaning as those in the Remote node Setup (See Table 5-1).
Once you have completed filling in this menu, press [Enter] at the message [Press ENTER to
Confirm...] to save your configuration, or press [Esc] at any time to cancel.