ZyXEL Communications Prestige 100WH - Manual (Page 112)

Prestige 100WH Internet Access Router
10-10 Chapter 10 System Maintenance
The following Table describes the eight diagnostic test options available in Menu 24.4.
Table 10-3. System Maintenance Menu Diagnostic Test Options
Fields Description
Drop WAN Port This command will drop the current call.
Reset WAN Port This command will reset the WAN Port.
Redirect to WAN Port This command will redirect the keyboard to the WAN Port. Anything you type
will be sent to the WAN device and the device’s response will be shown on
your terminal.
Internet Setup Test This test checks to see if your Internet access configuration is correct. When
this option is chosen, your Prestige will call the ISP and perform the PPP
negotiations. If everything is working properly, you will receive an appropriate
response. Otherwise, note the error message and consult your network
administrator.
Ping Host This diagnostic sends an ICMP echo packet to the remote host and shows
you the round-trip time when the Prestige gets a response. This is to test if the
host is reachable via TCP/IP.
Reboot System This option reboots the system.
Command Mode This option allows you to enter the command mode. This mode allows you to
diagnose and test your Prestige using a specified set of commands.
Manual Call This option allows you to manually place a call to a remote node. The Prestige
will show you traces of what is happening during the call setup and PPP
negotiation.